Strut-and-Tie Calculator
Strut-and-tie models to EN 1992-1-1 6.5: a deep beam, a hammerhead pier cap, a dapped end, a frame corner - or your own model of nodes, struts and ties over a wall with openings. The member forces by equilibrium, every strut, tie and node checked, with a step-by-step calc sheet. (SANS 10100-1 has no strut-and-tie method: this is the Eurocode route.)
EN 1992-1-1 6.5 · Annex J
Model
m
MPa
MPa
Geometry and load
m
m
kN
kN/m
m
m
m
kN
kNm
m
m
m
m
mm²
Ties As / largest strut EN 1992-1-1 6.5—
Plates, tie zone, anchorage
m
m
m
m
mm
kN
mm
mm
Detailing your statement
Own model m, kN; node numbers from 1
The model must be statically determinate (members + reactions = 2 × nodes); else it is NOT CHECKED. Forces by equilibrium only.
Model
Model, member forces and reactions
Design checks
| Check | Clause | Demand / capacity | Utilisation | Result | |
|---|---|---|---|---|---|
| Checking on the STATIX server… | |||||
Check details as text
—
—
pick a model and enter it
Result
| Model | — |
| Equilibrium Σ loads + Σ reactions | — |
| Lever arm z / strut angle θ | — |
| Tie force T / As needed | — |
| Members struts / ties | — |
Step-by-step calculation
Loading the calc sheet from the STATIX server… Start your free 14-day trial for every check and the calc sheet.
Deep members here, the beams and corbels next door
Slender beams go to the RC beam calculator, short cantilevers to the corbel calculator; this page takes the regions where plane sections do not stay plane. Free 14-day trial.