Anchor Reinforcement Calculator
The reinforcement round an anchor that takes over from the concrete: in tension the bars carry the load instead of the concrete cone (EN 1992-4 7.2.1), in shear towards an edge they carry it instead of the edge failure (7.2.2). The steel and the anchorage of the bars, and the ratios βN,re / βV,re for the anchor's interaction check, with every check and a step-by-step calc sheet.
EN 1992-4 7.2
Concrete & steel
MPa
MPa
mm
Actions most loaded anchor
kN
Shear towards the edge
kN
mm
mm
mm
βN,re / βV,re—
Bars round the most loaded anchor EN 1992-4 7.2.1.2 / 7.2.2.2
| Bars | n | Size | From the anchor mm | l1 mm | End |
|---|---|---|---|---|---|
| Tension | |||||
| Edge |
Confirm these two to complete the check (they are your statements; until then the result reads NOT CHECKED).
Each set: the number of bars effective for the most loaded anchor, their size (φ ≤ 16), their distance from the anchor (tension: ≤ 0,75 hef; edge: ≤ 0,75 c1) and their anchorage length l1 inside the cone / break-out body (≥ 4φ hooked, 10φ straight). Leave n blank for no bars. Until both boxes are ticked the result is NOT CHECKED.
Scope: this page checks the reinforcement round ONE anchor (the most loaded fastener) that takes the concrete cone (tension, EN 1992-4 7.2.1.9) or the concrete edge failure (shear, 7.2.2.6). The anchors' own checks - steel, pull-out, splitting, blow-out, pry-out - and the base plate, lug plate and welds stay on the base plate calculator. With effective reinforcement the cone / edge failure need not be checked (7.2.1.2(1), 7.2.2.2(1)): use βN,re and βV,re from here in place of the cone / edge ratios in the N + V interaction (Table 7.3 line 2, eq. 7.57).
Section
Tension: the cone and the bars; shear: the edge and the edge bars
Design checks
| Check | Clause | Demand / capacity | Utilisation | Result | |
|---|---|---|---|---|---|
| Checking on the STATIX server… | |||||
Check details as text
—
—
enter the anchor, the actions and the bars
Result
| Bond strength fbd | — |
| Tension NEd,re / NRd min(steel, anchorage) | — |
| Edge NEd,re / NRd min(steel, anchorage) | — |
| βN,re tension ratio | — |
| βV,re shear ratio | — |
Step-by-step calculation
Loading the calc sheet from the STATIX server… Start your free 14-day trial for every check and the calc sheet.
The bars here, the anchors next door
The anchors themselves, the base plate, the lug and the welds are on the base plate calculator - carry βN,re / βV,re there. Free 14-day trial.